Bringing Ladder Safety Over the Top
The most awkward and dangerous maneuver of using any extension ladder is entering and exiting at the top. It’s an accident just waiting to happen…so be it any wonder that 80% of all falls from ladders happens at the top? Solving this safety issue was at the heart of our walk through concept.
Designed to attach over the top of the ladder, the Ladder Innovations Walk Through by AIC requires no tools, drilling or bolting to hold it securely in place. The Walk Through is designed with an off setting right, left flair that allows for safer enter on and off the top of the ladder even if you’re wearing a loaded up tool belt. In our opinion, adding the Walk Through to your ladders is one of the strongest statements regarding safety in the workplace you can make.
WT02 or WT04- unit price $325.00
This antiquated, unbalanced and
dangerous maneuver is the #1 cause of ladder
overturning or moving.
1991 National Safety Council study;
"A Scenario Analysis of Ladder Fall Accidents."
- Patented design allows centered, balanced and much safer access at the top.
- Railings exceed OSHA’S 200 lb. guard rail & ANSI 1000 lb. ladder test standards for trusting strength.
- 40” railing height from top rung, OSHA compliant 3’ extension rule for portable ladders; 1926.1053(b)(1)
- Anti-slip textured railings for slippery, frosty mornings.
- Knob tightens stainless steel clamp for maximum effect. Does not harm the integrity of ladder.
- Allows closing the dangerous, open gap of OSHA’s guardrail requirement for increased fall protection.
- Attach Control Lines to WT02 railings for easier erecting of controlled access zones.
- Aluminum construction provides only 12 lbs of weight for easy maneuvering.
- Holes on sides leave rung openings exposed for easy accessory access.
- Available with Mil. Spec. 8625 Type III Class 2 hard coat for non-conductive applications to 2,000 volts.
Ladder must be extended two rungs for Walk Through Railing System to fit.
Tighten Knobs as tight as possible by hand only.
Do not lower fly section below 2nd rung while Walk-Through is installed.
Models available to fit most any extension ladder up to 375 lbs rated. Measure beam dimensions to determine model; most popular isWT02 for beams under 3.5” x 1.375”, WT04 for larger beam sizes up to 4.250” x 2” FD10 for most popular Duo Safety brand ladders.FD5for most popular Alco-Lite brand ladders used by most fire departments.
WT02 and WT04 - Licensed Exclusively to Guardian Fall Protection Inc. Seattle, WA 800-466-6385
Available from AIC
FD5 & FD10 $379.95
Note aluminum ladders with beams only 2.75" wide require a longer Knob for proper fit. Please call for information.
Safety is Not Expensive. . . It’s Priceless
Fire Fighter Endorsed
Award Winning
The Obvious Choice for Ladder Safety
